iC100 iConnectorLE™ is a low-cost version of Connect One’s iConnector™. It is a small adapter that enables installed devices to easily and cost-efficiently connect to the Internet via cellular modems and data-enabled cellular phones that use CDMA, CDMA2000 1xRTT, GPRS, GSM and TDMA networks. iConnectorLE provides “Instant Internet”™ connectivity for installed legacy devices by eliminating the need for any hardware modification to the host device.
The Internet engine inside iConnectorLE is Connect One’s firmware-based iChip™ CO110PC Internet Controller™, which stores the Internet protocol stack in updateable flash memory. Simply install iConnectorLE between your device and a cellular modem or data-enabled phone in order to Internet-enable your host device.
Connect One’s AT+i™ protocol eliminates the need for Internet programming and minimizes changes to the host application. The optionally available plug-and-play SerialNET™ mode of operation completely eliminates the need for changes to the host application, as it is a direct serial-to-Internet port server.
iConnectorLE plugs into the host device’s serial port via a female DB-9 connector or the evaluation extension board. It connects to the modem/phone via a male DB-9 connector. iConnectorLE is powered through pin 9 of the DB-9 connector to the host device, or via an external power source applied to the evaluation extension board.
Internet Protocols:
· Standard protocols: PPP, IP, UDP, TCP, HTTP client, and DNS
· Optional additional protocols: SMTP send and FTP send/receive clients (specify firmware version ESFT)
· Optional SerialNET mode: specify firmware version SNET
· Includes 10 simultaneous TCP or UDP active sockets and two listening sockets
· Includes RAS server
Hardware Description:
· Size: 53 x 33 x 17 mm (2.1 x 1.3 x 0.67 in.) shell only
· Weight: 30g (1 oz.)
· Operating Humidity: 90% maximum (non-condensing)
· Operating temperature: better than 0° to 70°C (32° to 158° F)
· Power Supply Input: 5-12 VDC
· Current Consumption: 75mA
· Connectors: 2 DB-9 Male/Female
· Host Interface: RS-232, Power and TTL Input
· Modem Interface: RS-232
Performance Specifications:
· Host Data Rate: up to 230 kbps.
· Serial Data Format (AT+i mode): Asynchronous character; binary; 8 data bits; no parity; 1 stop bit.
· Serial Data Format (SerialNET mode): Asynchronous character; binary; 7 or 8 data bits; odd, even or no parity; 1 stop bit.
· Standard Operating Mode: Full duplex; auto redial, tone dialing.
· Flow Control: hardware (DTR, RTS, CTS, DCD) and software flow control.
Approvals:
· FCC Part 15, FCC Part 68, CE Mark Class B Pending
