iConnector™ iC101 is a small adapter that enables installed devices to connect to the Internet via wireless modems and data-enabled phones that use AMPS, CDMA, CDMA2000 1xRTT, CDPD, GPRS, GSM, iDEN, and TDMA networks. iConnector provides “Instant Internet™” connectivity for installed legacy devices by eliminating the need for any hardware modification to the host device. Simply install iConnector between your device and a wireless modem or data-enabled phone to Internet-enable your host device.
Connect One’s AT+i™ protocol eliminates the need for Internet programming and minimizes changes to the host application. Connect One’s SerialNET™ mode completely eliminates the need for changes to the host application, as it is a direct serial-to-Internet port server.
iC101 plugs into the host device’s serial port via a male or female DB-9 connector. It connects to the modem/phone via a male DB-9 connector. iConnector may be powered through pin 9 of the DB-9 connector to the host device, or via an external power source.
The Internet engine inside iConnector is Connect One’s firmware-based, remotely updateable iChip™ CO661 Internet Controller™, which stores the Internet protocol stack in flash memory.
Ordering Information
| Part Number | Description |
iC101-FM-I-0-110/220 | iConnector with 110/220V power supply |
iC101-FM-I-1 | iConnector, power via DB9 pin 9 |
Internet Protocols:
· PPP, IP, UDP, TCP, SMTP, POP3, MIME, HTTP, FTP, TELNET, DNS
· Up to 10 simultaneous full-duplex UDP and TCP sockets and two listen sockets
· Includes Web server / 32KB Web site.
· Includes WAP server for device management via a WAP browser.
Wireless Modem/Data-Enabled Phone Support:
· Works with wireless modems/data-enabled phones that support AT commands via an RS-232 interface.
Hardware Description:
· Size: 42.67 x 69.19 x 20.17 mm (1.68 x 2.724 x 0.794 in.)
· Weight: 37 g (1.3 oz.)
· Operating Humidity: 90% maximum (non-condensing)
· Commercial Temperature Range: 0° to 70° C (32° to 158° F)
· Industrial Temperature Range: -40° to 85°C (-40° to 185° F)
· Power Supply Input: 5-24 VDC
· Power Consumption: 0.4 W
· LEDs: TX, RX, Carrier Detect, Ring, Power
· Connectors: 2 DB-9, 1.3 mm power jack
· Host Interface: RS-232
Performance Specifications:
· Host Data Rate: up to 115,000 bps
· Serial Data Format (AT+i mode): Asynchronous character; binary; 8 data bits; no parity; 1 stop bit.
· Serial Data Format (SerialNET mode): Asynchronous character; binary; 7 or 8 data bits; odd, even or no parity; 1 stop bit.
· Standard Operating Mode: Full duplex; auto redial, tone dialing.
· Flow Control: hardware (DTR, RTS, CTS, DCD) and software flow control.
Approvals:
· FCC Part 15, FCC Part 68, CE Mark Class B Pending
Warranty:
· 1-year limited warranty
